Isolate mode in Element Explorer narrows to one category at a time
When reviewing a model with many element categories visible at once, it can be hard to focus on one system — structural columns, doors, and MEP elements all compete for attention in the same view.
Isolate mode is now available in the Element Explorer panel. Select any element category and activate isolate mode to hide everything else in the viewer — only the elements in that category remain visible. Each category in isolate mode also shows its configured measurement type, so you can read quantities alongside the geometry without switching between panels or views.
To use it, open the Element Explorer from the viewer toolbar, browse to the category you want to focus on, and activate isolate mode. The rest of the model steps back, leaving only that category lit. Deactivate isolate mode to restore the full model view.
This works across all model elements surfaced in the Explorer. If a category has a measurement type configured (for example, floor area in square feet or linear length in feet), that figure appears alongside the isolated elements.